view construction DC700G-FT

Space required on doors for standard mounting on hinge side

Left handed shown in diagram
Right handed is the reverse

Installation dimensions in compliance with EN 1154 Supplementary Sheet 1; standard hinge-side mounting

Left handed shown in diagram
Right handed is the reverse

Notice

The positions of the locking components on the guide rail and mounting plate are designed in such a way that escape door strikes and latch bolt are correctly aligned when installed in a flush position (flush-fitted doors).
Adjustment option on electric strike (FaFix® ) of +/- 1 mm and latch bolt lock of +6/-3 mm mean that smaller differences in measurements can be compensated for.
In the case of doors with an overlapping door leaf (narrow or wide rebate), the following spacer plates must be used to ensure that the guide rail and mounting plate are in a flush position when on top of one another.

Spacer Plate DCFA01

For shimming guide rails over ASSA ABLOY drilling pattern. For use on narrow-rebate doors with a max. door leaf overlap of 8 mm.

Spacer Plate DCFA02

For shimming guide rails over ASSA ABLOY drilling pattern. For use on wide-rebate doors with a max. door leaf overlap of 18 mm.

Replacement Plate DCFA03

For mounting guide rail over existing drill holes, for flush-fit doors and narrow rebate doors with door leaf overlap up to 8 mm.

Replacement Plate DCFA04

For mounting guide rail over existing drilling pattern, for wide-rebate doors with door leaf overlap up to 18 mm.

Mounting and Replacement Plate DCFA05

Mounting plate for narrow frames. For mounting over ASSA ABLOY drilling pattern and over existing drill holes when the guide rail is replaced. For use on narrow-rebate doors with a max. door leaf overlap of 8 mm

Mounting and Replacement Plate DCFA06

Mounting plate for narrow frames. For mounting over ASSA ABLOY drilling pattern and over existing drill holes when the guide rail is replaced. For use on wide-rebate doors with a max. door leaf overlap of 18 mm.